Electric ovensBake and Broil Elements
If the bottom coil has a visible break or the oven only heats from the top, the bake element is the usual suspect. Hidden elements under a smooth floor panel need the floor pulled, which the pro handles during the visit.
- Element resistance and ground test
- Hidden bake element access and swap
- Broil element and terminal check
Gas ovensBake and Broil Igniters
When you hear the oven try, see a glow, but never get flame, the igniter is likely drawing too little current. An amperage draw test with a clamp meter tells the technician in minutes, and the broil igniter gets checked the same way.
- Igniter amperage draw test
- Gas safety valve check
- Broil igniter diagnosis
TemperatureSensor, Calibration and Hot or Cold Ovens
An oven that burns cookies or leaves bread raw usually has a bad temperature sensor or a calibration offset. Many RTD sensors read about 1,080 ohms at room temperature; the pro checks yours against the tech sheet and verifies the cavity with a thermocouple probe.
- RTD sensor resistance test
- Thermocouple probe temperature check
- Calibration and offset adjustment
Self-cleanDoor Locks and Thermal Fuses
Ovens often fail during or right after self-clean. The lock motor can jam with the door shut, or the thermal fuse can blow and kill power to the whole oven. The pro tests the motor, the switch and the fuse before quoting.
- Door lock motor and switch test
- Releasing a door stuck locked
- Thermal fuse and wiring check
ConvectionConvection Fan and Element
Noise from the back wall or uneven browning in convection mode points to the fan motor or the ring element around it. The pro checks motor windings and element continuity with the panel off.
- Fan motor winding and bearing check
- Convection element continuity
- Fan blade and rear panel inspection
Controls and doorControl Boards, F-Codes, Hinges and Gaskets
F-codes, a blank display, or relays that click without heat all lead to the electronic range control or relay board. Sagging doors, broken hinges and torn gaskets that leak heat get fixed on the same visit.
- Fault code and relay output testing
- Control or relay board replacement
- Door hinge and gasket replacement